Lucent-technologies Network Access Module Bedienungsanleitung PDF herunterladen (Seite 28)

Observe LED Behavior

3-4 INA Module Installation and Configuration Guide

Figure 3-4 T1/PRI Connection

Connect an Ethernet Cable

Use a category 5 twisted pair cable, as specified by the EIA/TIA-568-B wiring standard,

with an RJ-48C connector to connect the INA Ethernet connector (Figure 3-5) to the

nearest network hub. See “Ethernet Interface” on page B-2 for more information.

Figure 3-5 Ether0 Connection

Observe LED Behavior

Check the T1/PRI, system, and Ethernet LEDs to verify that the installed INA module is

operating properly.

T1/PRI LEDs

These LEDs (Figure 3-6) indicate the status of the T1/PRI line and operate in the same

way as on a 100D module. Make sure they indicate that the T1/PRI line is operating

properly.

T1/PRI port

1210-003

Ethernet port (Ether 0)

1210-004

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 74 75

Keine Kommentare

Lucent-technologies Network Access Module Bedienungsanleitung Seite 28